Inovance IS810N-INT Series - Basic Settings of the Trio Controller for OMET

IS810N-INT Series Servo System User Manual (Brief) Chapter 6 Commissioning Software
- 214 -
6.3.4 Basic Settings of the Trio Controller for OMET
The following part describes some simple conguration methods of the Trio MC4N controller
for IS810N.
1. Software installation
It is recommended to use a recent motion perfect4 version from Trio. The installation package
can be downloaded from Trio’s ofcial website.
2. Hardware connection interface
Trio recommends two connection methods. The mode of direct connection between the
computer and the controller is generally selected. The following part mainly introduces how to
use the direct connection mode.
Figure 1