Inovance IS810N-INT Series User Manual

- 150 -
IS810N-INT Series Servo System User Manual (Brief) Chapter 5 Keypad
5.5 User Password
After the user password function (H02-30) is enabled, only the authorized user is allowed to
set parameters; other operators can only view the parameters.
1) Setting a user password
The following gure shows the operation procedure of setting the password to "00001".
Figure 5-6 User password setting on the keypad
View value of
H02-30
Set password
Display
"E1.941"
Password takes
effect
Display "- - - - -"
Display "done"
Display
"Error"
End
Power-on
No
Yes
"ENTER"
Power-on again
"ENTER"
Yes
No
Enter preset
password
Password
correct?
"MODE"
Last digit
blinking?
Return t o H02-
30 display
Start
"ENTER"
"ENTER"
SET
SET
NOTE
*1: If the last digit does not blink, password protection is enabled. If the last digit blinks,
password protection is disabled or the correct password has been entered.
When changing the user password, enter the current password so that you enable the
parameter setting rights. Enter H02-30 again, and you can set a new password, according to
the method described in the preceding gure.
2) Canceling user password
Enter the existing user password, and set H02-30 to "00000". Then, the user password is
canceled.

Inovance IS810N-INT Series Specifications

General

Brand	Inovance
Model	IS810N-INT Series
Category	Servo Drives
Language	English