Inovance IS810N-INT Series - 4.7 RJ45 Communication Connection

- 111 -
IS810N-INT Series Servo System User Manual (Brief)Chapter 4 Wiring
4.7 RJ45 Communication Connection
RJ45 communication interfaces (RJ45A/RJ45B):
RJ45
communication
interfaces
(RJ45A/RJ45B)
CANH
CAN_H of CANopen/CANlink
communication signal
CANopen/CANlink
communication
protocol supported.
CANL
CAN_L of CANopen/CANlink
communication signal
CGND
Ground of CANopen/CANlink
communication signal
RS485+
Positive of RS485
communication signal
Used for RS485
internal bus, external
keypad, and PC
commissioning
(INoDriveShop)
RS485-
Negative of RS485
communication signal
CGND
Ground of RS485
communication signal
7 V
Power supply to an external
LCD keypad
Connect an external LCD
keypad.
The commissioning operation can be performed by connecting the RJ45 interface at the
back of the external LCD keypad to the RJ45B interface at the top of IS810 using a standard
network cable. The gure shows the interface of IS810.
The smart operating keypad (model SOP-20) is Inovance's new-generation commissioning
assistant for the frequency control system and supports products such as IS810, MD810,
MD880 and HE series and vehicle electronic drives. The smart operating keypad has a wide
power supply range and LCD display, supports multibus and applies to the single-motor/multi-
motor drive. The keypad provides the functions such as parameter settings, state monitoring,
simple oscilloscope, parameter copy, fault analysis and locating, program download and USB
relay.
Figure 4-24 Connection to SOP-20 using an RJ45A interface
For usage details, refer to the
SOP-20 Smart Operation Panel User Manual
.