Inovance IS810N-INT Series - 1.9 Usage Precautions

IS810N-INT Series Servo System User Manual (Brief) Chapter 1 Safety Information and Precautions
- 14 -
1.8.3 Disposal Precautions
CAUTION
CAUTION
When disposing the product, observe any applicable regulations or laws on recycling and
reuse of electronic products.
1.9 Usage Precautions
CAUTION
CAUTION
u
This drive is a general industrial product, and is not designed for use in machinery or
systems on which lives depend.
u
Wiring, operation, maintenance, and inspection of the product can only be conducted by
qualied person.
u
When selecting the screw tightening torque, consider the strength of the screw and material
of the installation part. Select a proper torque to tightly fasten a screw without damaging the
installation part.
u
Install a proper safety device when this product is to be used on machinery which may
cause serious accident or loss due to failures of the product.
u
Contact Inovance when this product is to be used for atomic energy control, aerospace
equipment, transport equipment, medical appliances, safety devices, or other equipment
that require high cleanliness.
u
Although this product has passed all QC tests, it may react unexpectedly due to faults
arising from ambient noise, static electricity, input power supply, wiring, parts, and so on.
Take mechanical safety measures into fully consideration to ensure safety in the application
site where all possible actions of the equipment occur.
u
When the motor shaft rotates without being grounded, the motor bearing may suffer from
electric corrosion or emit louder noise based on the actual mechanical and installation
conditions.
u
Faults of this product may cause smoke. Pay special attention to such condition when the
product is used in purication workshop or other similar environmentss.
u
Chip resistor disconnection or poor contact may occur due to sulfuration reaction if the
product is used in an environment with dense sulphur or sulfuretted gas.
u
Inputting a voltage far stronger than the rated voltage may cause damages to the internal
components, thus resulting in smoke or even a re.
u
End users shall decide whether the servo drive matches the structure, size, service life,
features, specication change of the equipment where the servo drive is to be installed and
its parts, and whether complies with local laws and regulations.
u
Note that use of this product beyond its specications is not guaranteed.
u
Some components of this product may be subject to change as we are dedicated to
continuous improvement of the product.