Inovance IS810N-INT Series - Using Noise Filter

- 129 -
IS810N-INT Series Servo System User Manual (Brief)Chapter 4 Wiring
4.12.2 Using Noise Filter
To prevent interference from power cables and reduce impact of the servo drive on other
sensitive devices, install a noise lter on the input side of the power supply according to
the input current. In addition, install a noise lter on the power cable of peripheral devices if
necessary. Observe the following precautions when installing and wiring the noise lter.
Do not put the input and output wires of the noise lter in the same duct or bundle them
together.
Figure 4-31 Separation noise lter input and output cables
Separate the grounding wire and output power wires of the noise lter.
Figure 4-32 Separation of the noise lter grounding wire and output power wires
Use a separate grounding cable as short and thick as possible for the noise lter. Do not
connect the grounding cable to other grounding devices.
Figure 4-33 Single point grounding
AC power supply
AC power supply
AC power supply
AC power supply
Noise
lter
Noise
lter
Noise
lter
Noise
lter
AC power supply AC power supply AC power supply
Noise
lter
Noise
lter
Noise
lter
Noise
lter
Noise
lter
Noise
lter
AC power supply
Noise
lter
Noise
lter
AC power supply
Noise
lter
Noise
lter
Noise
lter
Noise
lter
Noise
lter
Noise
lter
Servo
drive
Servo
drive
Servo
drive
Servo
drive
Shield grounding Shield grounding