Inovance IS810N-INT Series - 1.8 Check Item and Period

IS810N-INT Series Servo System User Manual (Brief)Chapter 1 Safety Information and Precautions
- 13 -
1.8 Check Item and Period
1.8.1 Normal Use Conditions
The required environment conditions are as follows:
Average ambient temperature: 30°C;
Average load ratio: below 80%;
D aily running time: less than 20 hours.
Perform daily and periodic checks according to the following table.
Type Period Check Item
Daily check Day
Check the ambient temperature, humidity, dust, and foreign objects.
Check whether there is abnormal vibration and noise.
Check whether the mains voltage is normal.
Check whether there is unexpected odor.
Check whether the air vent is stuck with ber threads.
Check whether the front end and connectors of the drive are clean.
Check whether there are foreign objects on the load side.
Periodic check Year
Check whether the fastening parts become loose.
Check whether the machine overheats.
Check whether the terminal block is damaged.
Check whether the fastening parts of the terminal block become
loose.
1.8.2 Prohibition
The machine can be dismantled and repaired only by Inovance.
The electrical and electronic components inside the servo system will suffer mechanical
wearing and aging after a long time of use. Replace the servo drive and motor according
to the instructions in the following table. If replacement is required, contact the dealer or
Inovance rst to check whether the components need to be replaced.
Object Type General Replacing Period Remarks
Drive
Bus lter capacitor About 5 years
The general replacing
period is only for
reference.
Even if the general
replacing period is
not reached, the
components can
be replaced when
abnormalities occur.
Cooling fan
2 to 3 years
(10,000 to 30,000 hours)
Aluminum electrolytic
capacitor on the circuit
board
About 5 years
Pre-charge relay
About 100,000 times
(depending on the use
conditions)
Pre-charge resistor
About 20,000 times
(depending on the use
conditions)
Motor
Bearing
3 to 5 years
(20,000 to 30,000 hours)
Oil seal 5,000 hours
Encoder
3 to 5 years
(20,000 to 30,000 hours)
Absolute encoder battery
Depending on the use
conditions