Inovance IS810N-INT Series - Page 64

IS810N-INT Series Servo System User Manual (Brief) Chapter 3 Installation
- 64 -
Cover Removal
Align the power terminal cover
with the clip of the bus seat.
Press the power terminal
cover to x it.
Insert the keypad. Align the upper cover with the
clip. Press the upper cover to
x it. Tighten the screw with a
screwdriver.
Insert the top end of the lower
cover into the bottom end of
the upper cover. Rotate the
bottom end of the lower cover
to x it.
The installation is completed.