Inovance MD800 Series - Page 97

Parameter Group
-96-
Max.: 12.000 Data type: UInt16
Default:
2.000
Change:
At once
Value Range:
0.000 V to 12.000 V
Description
When analog voltage correction is conducted on AI1, a correction curve is obtained based on two
points, each of which corresponds to a measured voltage and a displayed voltage. The measured
voltage is the voltage measured using a meter, and the displayed voltage is the AI1 voltage before
correction (U3-12).
AC-10
Extension card 1 - AI1 measured voltage 2
Address:
44042
Min.:
0.000
Unit:
V
Max.:
12.000
Data type:
UInt16
Default:
2.000
Change:
At once
Value Range:
0.000 V to 12.000 V
Description
When analog voltage correction is conducted on AI1, a correction curve is obtained based on two
points, each of which corresponds to a measured voltage and a displayed voltage. The measured
voltage is the voltage measured using a meter, and the displayed voltage is the AI1 voltage before
correction (U3-12).
AC-11
Extension card 1 - AI1 displayed voltage 2
Address:
44043
Min.:
0.000
Unit:
V
Max.: 12.000 Data type: UInt16
Default:
2.000
Change:
At once
Value Range:
0.000 V to 12.000 V
Description
When analog voltage correction is conducted on AI1, a correction curve is obtained based on two
points, each of which corresponds to a measured voltage and a displayed voltage. The measured
voltage is the voltage measured using a meter, and the displayed voltage is the AI1 voltage before
correction (U3-12).
AC-12
Extension card 1 - AI2 measured voltage 1
Address:
44044
Min.:
0.000
Unit:
V
Max.: 12.000 Data type: UInt16
Default:
2.000
Change:
At once
Value Range:
0.000 V to 12.000 V
Description
When analog voltage correction is conducted on AI1, a correction curve is obtained based on two
points, each of which corresponds to a measured voltage and a displayed voltage. The measured
voltage is the voltage measured using a meter, and the displayed voltage is the AI1 voltage before
correction (U3-13).
AC-13
Extension card 1 - AI2 displayed voltage 1
Address:
44045