VIsualEyes 515/525 - Additional Information Page 9
Timer
During testing (all tests) the timer will display how much time has elapsed or remains in the current test
based on Count Style (Figure 1.8.1). Based on the default system settings, the timer will provide audible
beeps and voice prompts at indicated intervals to prompt the examiner and provide audible feedback for the
elapsed or remaining time in the test. To change these settings, see the section 12.4 Timer settings.
Figure 1.8.1 Timer display
Further time may be added to the test during the procedure by pressing the Add Time button (Figure
1.8.2).This will add a further 30 seconds (default) to the time remaining on the counter.
Figure 1.8.2 Add Time button
1.9 Add Note
One can insert a note at a specific point in the raw trace, during or after testing by selecting Add Note
(Figure 1.9.1). This can also be used as an event marker to identify a unique event within the recording.
Figure 1.9.1 Add Note button
The time at which the note is inserted is shown with the line symbol:
The text for note taking is limited to 33 characters. It will be hidden in the traces, but will be uncovered when
hovering over or clicking on the note symbol. When printing the test in the report, the note added will be
displayed after the graphical printouts.
1.10 Add tests
To insert additional tests into the current testing session, use the Add Test button accessed from the test
menu on the testing screen.
Select the test menu button.
Figure 1.10.1 Test Menu button
To Next Page
Loading...
