Invacare ProSPIN X4 - Section 5 Maintenance Inspection Troubleshooting; Maintenance; Suggested Maintenance Procedures

SECTION 5—MAINTENANCE INSPECTION/TROUBLESHOOTING
Part No 1125104 33 ProSPIN™ X4™
SECTION 5—MAINTENANCE
INSPECTION/TROUBLESHOOTING
NOTE:Everysixmonthsorsooner,asnecessary,takeyourwheelchairtoaqualifiedtechnicianfor
athoroughinspectionandservicing.Regularcleaningwillreveallooseorwornpartsandenhance
thesmoothoperationofyourwheelchair.Tooperateproperlyandsafely,yourwheelchairmustbe
caredforjustlikeanyothervehicle.Routinemaintenancewillextendthelifeandefficiencyofyour
wheelchair.
Maintenance
 WARNING
After adjustments and before use, make sure all attaching hardware is securely
tightened, otherwise injury or damage may result.
CAUTION
DO NOT overtighten hardware attaching to the frame. This could cause damage to
the frame tubing.
Suggested Maintenance Procedures
1. Beforeusingthewheelchair,makesureallnutsandboltsaretight.Checkallpartsfor
damageorwearandreplace.Checkallpartsforproperadjustment.
 WARNING
DO NOT use WD-40, 3-in-1 oil, or other penetrating lubricants on quick-release
axles. Otherwise, binding and/or damage to the wheelchair may occur.
2. Clean/oilquick‐releaseaxlesonceaweekwithaTeflon™lubricant.
3. Periodicallycheckthebackfolddownmechanismstoensurethattheylocktheback
securelyinplace.Ifthebackdoesnotlockproperly,takethewheelchairtoaqualified
technicianfordisassembly,cleaning,orreplacementofthelocking
mechanism.WARNING
 WARNING
DO NOT use the wheelchair unless it has the proper tire pressure (p.s.i.). DO NOT
overinflate the tires. Failure to follow these suggestions may cause the tire to
explode and cause bodily harm.
4. Iftiresarepneumatic,recommendedtirepressureislistedonthesidewallofthetire.