Invacare ProSPIN X4 - Installing Clothing Guards; Installing and Removing a Seating System

SECTION 10—SEAT
ProSPIN™ X4™ 66 Part No 1125104
Installing Clothing Guards
NOTE:Forthisprocedure,refertoFIGURE10.4.
1. Positionthethreadedhalfclampontheoutsideofthewheelchairframe.
2. Positiontheunthreadedhalfclampon
theinsideofthewheelchairframe.
3. Looselyinstallthewasherandsocket
screwintotheunthreadedand
threadedhalfclamps.
4. Determinethedesiredrigidclothing
guardpositionandsecurelytightenthe
twohalfclampstogetherwiththe
socketscrew.
5. Inserttherigidclothingguardintothe
slotonthethreadedhalfclampas
showninFIGURE10.4.
6. RepeatSTEPS1‐4fortheoppositerigid
sideguard.
FIGURE 10.4 Installing Clothing Guards
Installing and Removing a Seating System
 WARNING
Invacare products are specifically designed and manufactured for use in conjunction
with Invacare accessories. Accessories designed by other manufacturers have not
been tested by Invacare and are not recommended for use with Invacare products.
1. Ensurethattheseatingsystemiscompatiblewiththiswheelchair.
2. RefertotheseatingsystemOwnerʹsManualforinstallationandremoval.
Half Clamp
Wheelchair
Frame
Socket
Screw
Washer
Threaded Half
Clamp
Slot