Invacare ProSPIN X4 - Adjusting the Flip-Up Footrest

SECTION 7—FRONT RIGGINGS
Part No 1125104 43 ProSPIN™ X4™
Adjusting the Flip-Up Footrest
NOTE:ThisprocedureisforfixedfrontframesONLY.
Adjusting Footplate Angle
 WARNING
When determining the angle of the footplate, make sure the rear of the footplate
does not interfere with the movement of the front casters.
NOTE:Forthisprocedure,refertoFIGURE7.4.
1. Loosen,butDONOTremovetheflatscrews,washersandlocknutsthatsecurethe
footplatetothetwofootresttubes.
2. Positionthefootplatetothenecessaryangletoaccommodatetheuser.
3. Retightentheflatscrews,washersandlocknuts.
Adjusting Footplate Depth
NOTE:Forthisprocedure,refertoFIGURE7.4.
1. Removetheflip‐upfootrestfromthewheelchair.RefertoInstallingAdjustableAngle
Flip‐upFootplateHingeonpage 41.
2. Loosen,butDONOTremovetheflatscrews,washersandlocknutsthatsecurethe
footplatetothefootresttubes.
NOTE:Observetheangleofthefootplateforreinstallation.
3. Movethefootplatetooneoftwopositionstoaccommodatetheuser.SeeDetail“A ” of
FIGURE7.4
4. Retightentheflatscrews,washersandlocknuts.
5. Reinstalltheflip‐upfootrestontothewheelchair.RefertoInstallingAdjustableAngle
Flip‐upFootplateHingeonpage 41.
FIGURE 7.4 Adjusting Footplate Angle - Adjusting Footplate Depth
Footplate
Footrest
Tube
Washers
Footrest Tube
Flat Screws
Locknuts
Washers
Position 1
Position 2
Footplate
DETAIL“A” - DEPTH POSITIONS