Invacare ProSPIN X4 - Installing Fabric Clothing Guards

SECTION 10—SEAT
Part No 1125104 65 ProSPIN™ X4™
Installing Fabric Clothing Guards
NOTE:Forthisprocedure,refertoFIGURE10.3.
1. Removetheseatcushion,ifnecessary.
2. Securethefasteningstrapsofthefabric
clothingguardstothefasteningstraps
ontheseatupholstery.
3. Reinstalltheseatcushion,ifnecessary.
4. Removethetwomountingscrewsthat
securethebackupholsterytotheback
canes.
5. Positionthe
D‐ringsonthemounting
holesinthebackcanes.
6. Reinstallthetwomountingscrews.
Torqueto20‐25in‐lbs.
7. Runthenyloncordevenlythroughthe
twoD‐rings.
8. Runthenyloncordthroughthecord
lock.
9. Pushstarwheelintocordlocktohold
thenyloncordinplace.
10. Tie
aknotinthenyloncordandcutthe
excess,ifdesired.
FIGURE 10.3 Installing Fabric Clothing
Guards
Fabric Clothing Guard
Fastening Strap
Seat Upholstery
Mounting
Screw and
D-ring
Card Lock
Mounting
Screw and
D-ring
Star Wheel
Nylon Card