Invacare ProSPIN X4 - Installing Fork Assembly Height Adjustment Spacers

SECTION 12—CASTERS, FORK AND FORK STEM ASSEMBLIES
Part No 1125104 83 ProSPIN™ X4™
Installing Fork Assembly/Height Adjustment Spacers
NOTE:Stemboltlengthbasedonset‐to‐floorheight,refertoChangingFrontSeat‐to‐FloorHeight
onpage 93toensureproperstemboltlengthbeforeinstallingtheforkassembly.
1. Insertstemboltthroughforkstem.
2. Performoneofthefollowing:
• StandardForks‐Usingalocknutandwasher,securetheheightadjustmentspacer
(ifneeded),spacerandforktothestembolt(Detail“A”).
•SuspensionFork(Detail“B”)‐
a. Using
alocknutandwasher,securetheheightadjustmentspacer(ifneeded),
spacerandsuspensionforktoptothestembolt
b. RefertoInstallingtheElastomer
onpage 86securethesuspensionforktopto
theelastomerandsuspensionforkbottom.
3. Installthefrontcaster.RefertoInstallingFrontCasteronpage 79.
FIGURE 12.4 Removing/Installing the Fork Assembly
Stem Bolt
Fork Stem
Height Adjustment
Spacer (If used)
Locknut
Spacer
Fork
Washer
Stem Bolt
Height Adjustment
Spacer (If used)
DETAIL “B”
SUSPENSION FORK
Spacer
Suspension Fork Top
Washer
Locknut
Suspension
Fork Bottom
Elastomer
Threaded Bushing
Mounting
Screws
Mounting Screws
DETAIL “A”
STANDARD FORK
Fork Stem