Invitrogen EVOS M5000 - Page 33

4.
If needed, readjust the brightness and focus, then click Capture.
The viewing area shows the image captured in the new channel superimposed on the image
captured in the previous channel.
A thumbnail of the image captured in the new channel is displayed along with the thumbnail of the
image fr
om the previously captured channel.
Repeat the above steps to capture each channel as needed.
5.
To remove a captured image from the memory buer, click the
X on the desired image, then click
the X again to remove only the selected image. To remove all captured images from the memory
buer, click the X on any of the captured images, then click
All(Clear All).
Chapter4Capture images
Capture images in a single channel
4
EVOS
™
M5000 Imaging System User Guide
33