Invitrogen EVOS M5000 - Adjust Objective Settings; Assign Objectives

Adjust objective settings
Assign objectives
After adding a new objective to the objective turret or replacing an older objective, assign the new
objective to the appropriate turret position. For instructions on how to remove an objective, see
“Change the objectives” on page110.
1.
Go to the Settings4Objectives tab.
2.
Find the newly installed objective in the Objectives list for the corresponding turret position.
3.
Click
Done.
IMPORTANT! For best results, calibrate the newly installed objective before using it in your
experiments (see
“Calibrate objective magnification” on page112.
Chapter11Configure instrument settings
Adjust objective settings
11
98
EVOS
™
M5000 Imaging System User Guide