Invitrogen EVOS M5000 - Install the UV Light Shield

5.
Using the light cube tool, loosen the two screws that secure the blank light cube to the instrument.
You do not need to remove the screws.
6.
Screw the light cube tool in to the threaded hole in the blank light cube, then lift the blank light
cube up and out of the micr
oscope. Store the blank light cube and the light cube tool in the
accessories box.
Note:
Store the shipping restraints and the light cube tool for future use in the accessories box
pr
ovided with your system. Always re-secure the X-Y stage with the stage lock pin and re-install the
light cube restraint before moving the instrument.
IMPORTANT! Before changing light channels, ALWAYS verify the light cube restraint has been
removed. Attempting to change the light channels while the restraint is in place can seriously damage
the mechanism. This type of damage is not covered by the manufacturer’s warranty.
Install the UV light shield
1.
Verify that the EVOS
™
Condenser Light Shield
™
is installed on the condenser assembly. The
condenser shield is pr
e-installed and helps reduce the potential eects of overhead lighting on
your image.
2.
Pull the condenser light shield out from the condenser head.
Chapter3Installation
Install the instrument
3
20
EVOS
™
M5000 Imaging System User Guide