10 Speakers application
The Speakers application enables you to assign lines to speaker channels.
The Speakers application on IQ/MAX TOUCH supports up to 32 speaker channels.
Unassigned speaker channels are empty.
Note
Use of the Speakers application requires the appropriate licenses and privileges. Speaker channel layout,
access to speaker channels, and the ability to talk on specific speaker channels are defined by an
administrator in the user profiles.
The actions supported in the Speakers application include:
•
Turn individual speaker channels on or off.
•
Turn all speaker channels on or off
•
Talk on a speaker channel using:
•
Push-to-talk (talk while holding down the Push-to-Talk button).
•
Push-to-latch or Slide-to-Latch (talk until you unlatch the channel).
•
Adjust the volume of individual speaker channels and the overall speaker volume in Speakers.
•
Mute a speaker channel or all speaker channels.
•
View speaker status.
•
Assign a line to a speaker channel.
•
Assign a speaker channel to speaker groups.
•
Replay speaker audio.
•
Send a speaker call to a handset.
•
Use solo mode.
•
Use spatial audio.
•
Use compact view mode.
•
Configure a talkback device for speakers and speaker groups
A visual indication of voice activity is displayed for all active speaker sessions, even if the lines are
muted locally but not if the lines are muted by the system (due to muting configuration). This enables
identification of lines that are broadcasting.
Note
If a speaker channel is accessed by a handset call with global muting, the speaker channel is muted at all
other extensions and no voice activity is shown for the channel. For more information, see How call
muting controls affect speaker users on page 146.
If calling party or calling line information is available for the line assigned to an active speaker channel,
the information is displayed.
127
IPC Proprietary Unigy 4.3
IQ/MAX TOUCH Turret User Guide
To Next Page
Loading...
