IPC IQ/MAX TOUCH - Toggling CLI Display; Suppressing Outgoing CLI

Tap the Get CLI button to display information for the caller, even if the line button is not set to display
CLI information.
The caller’s name or phone number is displayed, according to the CLI display preferences.
For more information, see Call Handling on page 164.
For an active or ringing call, tap the Get CLI button.
If caller information is available, the turret displays full CLI information for the caller in the Call
Notification area of the footer.
4.12.3 Toggle CLI display
Use a preprogrammed Toggle CLI button to control whether the name or number of the caller for
incoming calls is displayed on the turret.
This feature can be programmed at the turret by users with sufficient privileges, or it can be programmed
through the Unigy Management System.
When a call is received, the turret displays calling party information in the Call Notification area of the
footer.
Note
If CLI Toggle is applied when both handsets are in use, the CLI Toggle remains in effect until both
handsets are released.
To change the display for incoming calls, tap the Toggle CLI button.
The CLI display for the incoming extension switches from the current default setting (name or phone
number) to the alternative option: from name to number, or from number to name.
4.12.4 Suppress outgoing CLI information
Use a preprogrammed Suppress CLI button, before placing or answering a call, to suppress display of
the calling party identification at the far end.
Tap the Suppress CLI button before a call.
CLI information for an active call cannot be suppressed, because the information is sent when the call is
established.
This feature can be programmed at the turret by users with sufficient privileges, or it can be programmed
through the Unigy Management System.
Note
CLI suppression ends after each call. To suppress CLI information for new calls, the feature must be
enabled again.
1. To block calling information for a call you are making, tap the Suppress CLI button.
The Suppress CLI button is highlighted to indicate that the feature is enabled. The word Enabled is
also displayed on the button.
2. Initiate the call.
No calling identity information appears at the far end. The call shows as Restricted.
4.12: CLI 67
IPC Proprietary Unigy 4.3
IQ/MAX TOUCH Turret User Guide