7 Send to right handset
8 Scrubber
2. To play, pause or rewind, tap the appropriate control:
•
Play/Pause: Tap to play back the audio. Tap again to pause. The audio is played on the primary
speaker by default.
•
Rewind: Tap to rewind or reset the audio replay.
You can also use the scrubber to adjust the audio replay to a particular position.
3. Optionally, you can choose a destination for the audio replay:
•
Left speaker: Send audio replay to the external speaker (if available).
•
Right speaker: Send audio replay to the speaker on the Primary Module (default).
•
Left handset: Send audio replay to the left handset.
•
Right handset: Send audio replay to the right handset.
The destination chosen persists through logout and device reboot.
4. Tap the Replay audio icon again to close the Replay controls page.
10.4.8 View off-screen speaker activity
The off-screen speaker activity grid enables you to navigate to the speakers that are not presently visible
on the screen.
The off-screen speaker activity grid is located at the right side of the application area. See Speakers on a
hard turret on page 128 for an illustration.
To navigate to another set of speaker channels, tap that set of speaker channels in the off-screen speaker
activity grid. For example, if 32 channels are licensed and 16 are visible at a time, tapping the grid that
is not currently selected moves you to the next set of 16 channels.
10.4.9 Speaker solo mode
Speaker solo mode allows you to isolate the incoming audio of a single speaker channel while lowering
the volume of other active speaker channels. Speaker solo mode has no effect on transmit volume levels.
Speaker solo mode can only be enabled for one speaker channel at a time, and that speaker channel must
be turned on. The setting does not persist through device logout.
You can adjust the volume for all of the non-solo speaker channels by using the Non-solo Audio slider.
This sets the same volume for all of the non-solo channels.
Be aware of the following muting behavior when a speaker channel is in solo mode:
•
Press Mute on a speaker channel that is in solo mode, then that channel is muted and the other active
channels remain attenuated.
•
Press Unmute on the speaker channel that is in solo mode, then that channel is unmuted and the other
active channels remain attenuated.
•
Press Mute on a speaker channel that is in non-solo mode, then that channel is muted. The solo mode
speaker is not affected and the other active channels remain attenuated.
•
Press Unmute on the speaker channel that is in non-solo mode, then that channel is unmuted and is
attenuated. The solo mode speaker is not affected and the other active channels remain attenuated.
When a speaker channel is not in solo mode:
10.4: Use the Speakers application 137
IPC Proprietary Unigy 4.3
IQ/MAX TOUCH Turret User Guide
To Next Page
Loading...
