IPC IQ/MAX TOUCH - Talking on Speaker Channels

3. Do one of the following:
•
Tap Turn All Speakers ON. This turns on all speaker channels. The Turn All Speakers OFF
button is now blue and can be used.
•
Tap Turn All Speakers OFF. This turns off all speaker channels. The Turn All Speakers ON
button is now blue.
10.4.3 Talk on a speaker channel
Use Push-to-Talk or Push-to-Latch to talk on a speaker channel. Up to 10 simultaneous touches on 10
Push-to-Talk buttons are supported.
Prerequisites: The speaker channel is on (active) and connected to a remote party. A microphone,
handset, or headset is connected to your turret.
The Speaker Push-to-Talk button functions in two ways.
•
Push-to-Talk: Touch and hold the button while you speak through the microphone, handset, or
headset depending on the media device assigned. Release the button to stop transmitting.
•
Push-to-Latch: Touch and release the button. You can speak through the microphone, handset, or
headset without holding down the button. Touch and release the button again to stop transmitting.
Latch settings are configurable on the turret or from the UMS.
Note
When there is audio on a speaker channel (from far end or near end), the red audio activity bar within the
volume bar shows the audio activity. When audio ends, the audio activity bar disappears and a red line is
displayed at the bottom of the volume bar to indicate the last six seconds of time that elapses after the
audio stopped.
1. Tap the Speakers icon in the Navbar.
The Speakers application is displayed. See Speakers on a hard turret on page 128 for an illustration.
2. To speak on a channel:
•
If your speaker channel is set to Push-to-Talk, touch and hold the Push-to-Talk button.
•
If your speaker channel is set to Push-to-Latch, touch and release the Push-to-Talk button.
•
If your speaker channel is set to Push-to-Talk and you have the proper privileges, you can use
Push-to-Latch by touching the Push-to-Talk button and swiping up to latch the channel as shown
below.
132 10.4: Use the Speakers application
August 26, 2019 IPC Proprietary