EasyManua.ls Logo

JAC T9 - Page 121

JAC T9
248 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
113
Starting and driving
1
2
3
4
5
6
7
8
Notice
Notice
● When the engine is not started
and the ignition switch is at "ON"
position, you need to observe the
state of the preheating indicator
for diesel engine on the instrument.
After the preheating indicator goes
out, start the engine immediately.
The starting time of the engine
shall not exceed 8 s at a time, and
the interval between starts shall not
be less than 2 min. If the engine
still cannot be started after three
consecutive starts, stop starting
immediately and contact the after-
sales service provider for help.
The smart start-up function may not
work normally under the following
conditions:
(1)The smart key is not in the
vehicle;
Emergency start of engine
Stop of engine
If you cannot start the engine normally,
conduct the emergency start of engine in
the following ways:
1. Before starting the engine, place the
gear shift in "P" position and switch the
START switch to "ACC" position.
2. Press and hold the START switch for 15
s without depressing the brake pedal to
conduct the emergency start of engine.
Stop the engine as follows:
1.After the vehicle is completely stopped,
place the gear shift in "P" position.
(2)The smart key battery is too low;
(3)There are sites with facilities that
emit strong electromagnetic waves
nearby, such as television towers,
power stations and radio stations;
(4)The smart key is in contact with
or covered by metal objects;
(5)The smart key is placed in a
corner of the vehicle.
2. Depress the brake pedal and the
indicator turns green.
3. When the smart key is in the sensing
area, press the START switch to start the
engine.
2.Press the START switch to stop the
engine and switch it to "OFF" position.
Emergency stop of engine
Press and hold the START switch for about
3 s or press it continuously for 3 times
within 3 s to conduct the emergency stop
of engine.
Warning
After running the engine under heavy
load or for a long time, let it idle for
3-5 min before stopping it. This is to
cool the engine evenly so as to avoid
deformation of some components
due to rapid cooling and spontaneous
combustion of engine.
Danger
● The steering power system will fail
to work when the vehicle is powered
o during running. Please use this
function with caution.

Table of Contents

Related product manuals