16
Safety
1. Move the front seats to the frontmost
position.
2. Recline the rear seat forward and remove
the seat headrest where the child seat
needs to be installed. Insert the child seat
into the ISOFIX connector.
ISOFIX is a standard protection system
specially designed for child seats. Child
seats can be installed with ISOFIX on the
two rear outboard seats.
Installation steps are as follows:
Installation of child seat using child
seat anchorage
Notice
● For a rear-facing child seat, adjust
the headrest to the lowest position or
remove it.
● For a front-facing child seat, remove
the headrest if it aects the tting
between the child seat backrest and
the rear seat backrest.
● If a booster cushion is used, it is
forbidden to remove the headrest,
and the top of the headrest shall be
adjusted to a position that is ush
with or closest to the top of the
child's head.
● For details of operation of seat, refer
to Chapter II.
3.When your child seat has an upper pull
strap, there are corresponding upper pull
strap xing points on the rear seats of
the vehicle. The location is shown in the
diagram.
Top tether anchorage
Top tether strap
To Next Page
Loading...
