45
Instruments and control
1
2
3
4
5
6
7
8
1. High beam indicator (blue)
2. Low beam indicator (green)
3. Front fog lamp indicator (green)
4. Rear fog lamp indicator (yellow)
8. Driver’s seat belt indicator (red)
5. Position lamp indicator (green)
6. Turn signal lamp/hazard warning
indicator (green)
7. Electronic Parking Brake (EPB)
working indicator (red)
This indicator will light
up when the high beam
is turned on or when a
warning signal is issued by
ashing the high beams.
This indicator will light
up when the low beam is
turned on.
This indicator will light up
when the front fog lamp is
turned on.
This indicator will light up
when the rear fog lamp is
turned on.
When the ignition switch is
in the "ON" position, if the
driver is not wearing a seat
belt, this indicator will ash
continuously until the driver is wearing a
seat belt, and this indicator will go out.
This indicator will light up
when the position lamp is
turned on.
When the turn signal
is turned on, the left or
right turn indicator on the
instrument panel ashes.
When the hazard warning switch is
pressed, the left and right turn indicators
ash simultaneously.
When the ignition is in the
"ON" position, the system
rst performs a self-
check. If the EPB is not
activated, the EPB working indicator will
light up for a few seconds and then goes
out. If the EPB is activated, this indicator
will continue to light up until the EPB is
released.
If this indicator does not light up, contact
an after-sales service store for maintenance
as soon as possible.
After the ignition switch is turned o, the
EPB is automatically activated, and the
indicator will continue to light up for 30
seconds.
Warning
● If this light does not ash, ashes
frequently, or does not light up at all,
it indicates a malfunction in the turn
signal system. At this point, contact
an after-sales service store as soon as
possible for maintenance. Otherwise,
other drivers on the road cannot see
your turn signals.
To Next Page
Loading...
