Juniper EX4300 Series

power supplies are shipped with AC power cords with the C13 coupler type and the 1100 W AC power
supplies and 1400 W AC power supplies are shipped with AC power cord with the C15 coupler type as
described by Internaonal Electrotechnical Commission (IEC) standard 60320. The plug end of the
power cord ts into the power source outlet that is standard for your geographical locaon.
NOTE: In North America, AC power cords must not exceed 14.75  (4.5 m) in length, to comply
with Naonal Electrical Code (NEC) Secon 400-8 (NFPA 75, 5-2.2) and Canadian Electrical
Code (CEC) Secon 4-010(3).
The tables in this topic list the AC power cords specicaons provided for dierent power supplies for
each country or region.
• Table 43 on page 106—Power cords for 350 W AC for EX4300 switches except EX4300-48MP and
EX4300-48MP-S switches and 715 W AC power supplies for EX4300 switches
• Table 44 on page 108—Specicaons of power cords used to connect EX4300 switches to C13
power
• Table 45 on page 109—Power cords for 1100 W AC power supplies for EX4300 switches and
1400 W AC power supplies for EX4300-48MP and EX4300-48MP-S Switches
Table 43: AC Power Cord
Specicaons for 350 W Power Supplies for EX4300 Switches Except
EX4300-48MP and EX4300-48MP-S Switches and 715 W AC Power Supplies for EX4300 Switches
Country/
Region
Electrical
Specicaons
Plug Standards Juniper Model
Number
Graphic
Argenna 250 VAC, 10 A, 50 Hz IRAM 2073 Type
RA/3
CBL-EX-PWR-C13-
AR
No graphic available
Australia 250 VAC, 10 A, 50 Hz AS/NZS 3112 Type
SAA/3
CBL-EX-PWR-C13-
AU
Brazil 250 VAC, 10 A, 50 Hz NBR 14136 Type
BR/3
CBL-EX-PWR-C13-
BR
No graphic available
106