Juniper EX4300 Series

• Congure out-of-band management —Congure the management port. In out-of-band
management, you use a dedicated management channel (MGMT port) to connect to the
management device. Specify the IP address and gateway of the management interface. Use this
IP address to connect to the switch.
7. Specify the SNMP read community, locaon, and contact to congure SNMP parameters. These
parameters are oponal.
8. Specify the system date and me. Select the me zone from the list. These opons are oponal.
9. The congured parameters are displayed. Enter yes to commit the conguraon. The conguraon
is commied as the acve conguraon for the switch.
10. (For EX4500 switches only) Enter the operaonal mode command request chassis pic-mode
intraconnect to set the PIC mode to intraconnect.
You can now log in with the CLI or the J-Web interface to connue conguring the switch. If you use the
J-Web interface to connue conguring the switch, the Web session is redirected to the new
management IP address. If the connecon cannot be made, the J-Web interface displays instrucons for
starng a J-Web session.
SEE ALSO
Connecng and Conguring an EX Series Switch (J-Web Procedure)
Installing and Connecng an EX2200 Switch
Installing and Connecng an EX2300 Switch
Installing and Connecng an EX3200 Switch
Installing and Connecng an EX3300 Switch
Installing and Connecng an EX3400 Switch
Installing and Connecng an EX4200 Switch
Installing and Connecng an EX4300 Switch | 170
Installing and Connecng an EX4550 Switch
Installing and Connecng an EX4500 Switch
Installing and Connecng an EX6210 Switch
Installing and Connecng an EX8208 Switch
Installing and Connecng an EX8216 Switch
244