Juniper EX4300 Series User Manual

• EX4300 switches except EX4300-48MP and EX4300-48MP-S switches—Connect the cable to
the port labeled MGMT on the rear panel of the switch.
• EX4500 or EX4550 switch—Connect the cable to the port labeled MGMT on the front panel
(LCD panel side) of the switch.
• EX4650 switches—Connect the cable to the port labeled CON on the rear panel of the switch.
• EX6200 switch—Connect the cable to one of the ports labeled MGMT on the Switch Fabric and
Roung Engine (SRE) module in slot 4 or 5 in an EX6210 switch.
• EX8200 switch—Connect the cable to the port labeled MGMT on the Switch Fabric and Roung
Engine (SRE) module in slot SRE0 in an EX8208 switch or on the Roung Engine (RE) module in
slot RE0 in an EX8216 switch.
These ports are congured as the DHCP server with the default IP address, 192.168.1.1. The
switch can assign an IP address to the management PC in the IP address range 192.168.1.2 through
192.168.1.253.
3. From the PC, open a Web browser, type hp://192.168.1.1 in the address eld, and press Enter.
4. On the J-Web login page, type root as the username, leave the password eld blank, and click
Login.
5. On the Introducon page, click Next.
6. On the Basic Sengs page, modify the hostname, the root password, and date and me sengs:
• Enter the hostname. This is oponal.
• Enter a password and reenter the password.
• Specify the me zone.
• Synchronize the date and me sengs of the switch with the management PC or set them
manually by selecng the appropriate opon buon. This is oponal.
Click Next.
7. Use the Management Opons page to select the management scenario:
NOTE: On EX2300 and EX3400 switches, you cannot create a new VLAN for management.
On EX4500, EX6210, and EX8200 switches, only the out-of-band management opon is
available.
• Congure in-band management . In in-band management, you congure a network interface or
an uplink module (expansion module) interface as the management interface and connect it to
the management device.
In this scenario, you have the following two opons:
247

Juniper EX4300 Series Specifications

General

Product Series	EX4300 Series
Power Consumption	Varies by model and configuration
Virtual Chassis Technology	Up to 10 switches
Software	Junos OS
Ports	24-port and 48-port models
10GBASE SFP+ Ports	Up to 8 ports
40GBASE QSFP+ Ports	2
Uplink Ports	Up to 4 ports
Jumbo Frames	Up to 9216 bytes
Operating Temperature	0°C to 45°C
Relative Humidity	5% to 90% noncondensing
Input Voltage	100 to 240V AC
Power Supply	AC or DC
Power Supply Options	AC or DC
Stacking	Yes
Layer 2 Features	Includes VLAN, STP, RSTP, MSTP, LACP
Layer 3 Features	OSPF, BGP
Management	CLI, Web GUI, SNMP
Security Features	DHCP snooping
QoS	8 queues per port, DSCP
Storage Temperature	-40°C to 70°C