Juniper EX4300 Series - Page 68

Table 11: LCD Panel Menu Opons in EX4300 Switches (Connued)
Menu Label Descripon
MAINT
(Maintenance
Menu)
The Maintenance menu has the following opons to congure and troubleshoot the
switch:
• SYSTEM HALT?—Choose one of the following:
• Press Enter to halt the switch. Press Enter again to conrm the halt.
• Press Menu to go to the next opon in the Maintenance menu.
• SYSTEM REBOOT?—Choose one of the following:
• Press Enter to reboot the switch. Press Enter again to conrm the reboot.
• Press Menu to go to the next opon in the Maintenance menu.
•
LOAD RESCUE?—Choose one of the following:
•
Press Enter to roll back the switch to the previous valid conguraon. Press Enter
again to conrm the rollback.
• Press Menu to go to the next opon in the Maintenance menu.
• REQUEST VC PORT?—Choose one of the following:
• Press the Enter buon to congure an uplink module port or a built-in QSFP+ port
to be a VCP or to delete a VCP from the switch conguraon (when you delete the
VCP, the port is reset to be an uplink module port or a network port).
• Press the Menu buon to go to the next opon in the Maintenance menu.
• FACTORY DEFAULT?—Choose one of the following:
• Press Enter to restore the switch to the factory default conguraon. Press Enter
again to conrm the restoraon. The LCD panel ashes a success or failure
message, aer which it displays the Idle menu.
• Press Menu to go to the next opon in the Maintenance menu.
• ENTER EZSETUP?—Choose one of the following:
• Press Enter to launch EZSetup. Press Enter again to conrm the launch.
58