Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Type Event: This message reports an event, not an error
Severity notice
Facility LOG_PFE
ASP_IDS_LIMIT_PKT_RATE_BY_PAIR
System Log Message syslog-prefix error-code: proto protocol-id (protocol-name),
source-interface-nameseparatorsource-address:source-port ->
destination-addressdestination-port, event-type
Description The stateful firewall discarded the packet with the indicated characteristics, because
the number of packets per second (aggregated over all monitored flows) exceeded the
intrusion detection services (IDS) limit configured by the 'packets' statement at the [edit
services ids rule <rule-name> term <term-name> then session-limit by-pair] hierarchy
level. The discarded packet contained the indicated information about its protocol
(numerical identifier and name), source (logical interface name, IP address, and port
number), and destination (IP address and port number).
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_PFE
ASP_IDS_LIMIT_PKT_RATE_BY_SRC
System Log Message syslog-prefix error-code: proto protocol-id (protocol-name),
source-interface-nameseparatorsource-address:source-port ->
destination-addressdestination-port, event-type
Description The stateful firewall discarded the packet with the indicated characteristics, because
the number of packets per second (aggregated over all monitored flows) exceeded the
intrusion detection services (IDS) limit configured by the 'packets' statement at the [edit
services ids rule <rule-name> term <term-name> then session-limit by-source] hierarchy
level. The discarded packet contained the indicated information about its protocol
(numerical identifier and name), source (logical interface name, IP address, and port
number), and destination (IP address and port number).
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_PFE
ASP_IDS_NO_MEM_SHOW_CMD
System Log Message Not enough memory for show command
Description Intrusion detection services (IDS) could not service a request to show information from
IDS tables, because not enough memory was available.
Type Error: An error occurred
Severity critical
Copyright © 2010, Juniper Networks, Inc.80
Junos 10.3 System Log Messages Reference

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English