CHAPTER 44
L2ALD System Log Messages
This chapter describes messages with the L2ALD prefix. They are generated by the Layer
2 address learning process (l2ald), which supports the dynamic acquisition of information
about media access control (MAC) addresses in a Layer 2 bridge environment.
L2ALD_DUPLICATE_RBEB_MAC
System Log Message Duplicate RBEB mac has been detected (mac-address). LE already exists with pbbn_id
: pbbn-id. Rejecting LE create with pbbn_id :new-pbbn-id
Description The l2 learning process (l2ald) already has this particular BEB mac existing for a different
PBBN ID.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
L2ALD_GENCFG_OP_FAILED
System Log Message Unable to complete gencfg operation operation (major type, minor subtype): error-message
Description The Layer 2 address learning process (l2ald) could not send Layer 2 forwarding-related
information to the Packet Forwarding Engines, because the indicated operation failed
during configuration generation.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
L2ALD_IPC_MESSAGE_ERROR
System Log Message Message (type message-type, subtype message-subtype, opcode message-opcode)
received with error error-message
349Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...