CHAPTER 40
JDIAMETERD System Log Messages
This chapter describes messages with the JDIAMETERD prefix. They are generated by
the jdiameter process (jdiameterd). Jdiameter is an open source software implementation
of the Diameter Base Protocol that is written in Java.
JDIAMETERD_FUNC_HSHAKE_FAIL
System Log Message Application diameter-function cannot generate handshake, disconnecting
Description The Diameter process(jdiameterd) failed to generate handshake message to the process
that implements the Diameter-function. The connection was closed so that a new
connection with full resynchronization could be established.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
JDIAMETERD_FUNC_LOCACCEPT_NFOUND
System Log Message Path pathname does not match any application
Description The Diameter process(jdiameterd) rejected a RE function side connection because there
is no matching diameter-function.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
JDIAMETERD_FUNC_NSCK_LISTEN_FAIL
System Log Message Unable to listen on internal-ip
Description The Diameter process(jdiameterd) is unable to listen on the internal ip socket for function
side connections.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
311Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...