Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

CHAPTER 86
TASK System Log Messages
This chapter describes messages with the TASK prefix.
TASK_ABORT
System Log Message abort executable-name[pid] version version built by builder on date: error-message
Description The control protocol process terminated because of an internal error.
Type Error: An error occurred
Severity error
Facility ANY
Action Examine the messages that immediately follow this message in the system log for
information about possible causes.
Cause An internal software failure occurred.
TASK_ACTIVE_TERMINATE
System Log Message Exiting with active tasks: task-name
Description After receiving multiple termination requests, the control protocol process exited without
performing the indicated cleanup tasks.
Type Event: This message reports an event, not an error
Severity notice
Facility ANY
TASK_ASSERT
System Log Message Assertion failed executable-name[pid]: file "source-filename", line line-number: "message"
Description The source code for this process includes internal self-consistency checks. The process
terminated because a check failed, creating a diagnostic core dump for analysis by
technical support personnel and noting the number of the line in the source file where
the check failed.
Type Error: An error occurred
621Copyright © 2010, Juniper Networks, Inc.

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English