CHAPTER 60
MPLS_OAM System Log Messages
This chapter describes messages with the MPLS_OAM prefix. They are generated by the
Multiprotocol Label Switching (MPLS) Operation, Administration, and Maintenance
(OAM) process (mplsoamd), which supports traceroute operations for LDP label-switched
paths (LSPs).
MPLS_OAM_FANOUT_LIMIT_REACHED
System Log Message fec-address: traceroute fanout limit was reached
Description The traceroute fanout limit was reached.
Type Error: An error occurred
Severity info
Facility LOG_DAEMON
Action Raise the traceroute fanout limit parameter.
MPLS_OAM_INVALID_SOURCE_ADDRESS
System Log Message fec-address: source address ip-address is invalid
Description The traceroute utility is configured to use an invalid source address.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Configure traceroute to use a valid source address.
MPLS_OAM_PATH_LIMIT_REACHED
System Log Message fec-address: traceroute path limit was reached
Description The traceroute path limit was reached.
Type Error: An error occurred
Severity info
449Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...