Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

CHAPTER 79
SDXD System Log Messages
This chapter describes messages with the SDX prefix. They are generated by the Session
and Resource Control (SRC) process (sdxd), which provides a user interface for deploying
Internet services.
SDXD_BEEP_FIN_FAIL
System Log Message Graceful close of BEEP session failed
Description The Session and Resource Control (SRC) process (sdxd) could not send a request to
the SRC server to close a Blocks Extensible Exchange Protocol (BEEP) session. It sends
this request when the session becomes unconfigured.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
Cause The usual cause is that the session was already partially or completely closed.
Action None required. The sdxd process recovers automatically in this situation.
SDXD_BEEP_INIT_FAIL
System Log Message BEEP initialization failed
Description The Session and Resource Control (SRC) process (sdxd) could not initialize the Blocks
Extensible Exchange Protocol (BEEP), which it uses to connect to an SRC server.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause An internal software failure might have occurred.
SDXD_CHANNEL_START_FAIL
System Log Message Notification channel could not be started (error-code): message
589Copyright © 2010, Juniper Networks, Inc.

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English