Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

CHAPTER 21
DCD System Log Messages
This chapter describes messages with the DCD prefix. They are generated by the interface
process (dcd), which controls the physical interface devices and logical interfaces in the
routing platform.
DCD_GRE_CONFIG_INVALID
System Log Message Either tunnel key or clear-dont-fragment-bit must be configured for this GRE tunnel
(interface-name), to enable post fragmentation
Description This interface needs either the tunnel key or the clear-dont-fragment-bit to be configured
along with allow-fragmentation
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Configure either the tunnel key or clear-dont-fragment-bit for this tunnel
DCD_MALLOC_FAILED_INIT
System Log Message Memory allocation failed during initialization for configuration load
Description The interface process (dcd) could not dynamically allocate memory in preparation for
loading a configuration.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause A software bug caused a memory leak, or the routing platform had insufficient memory.
Action Contact your technical support representative.
DCD_PARSE_CFG_WARNING
System Log Message configuration-statement : warning-message
Description The interface-control process (dcd) found a discrepant configuration
227Copyright © 2010, Juniper Networks, Inc.

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English