Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

CHAPTER 17
CFMD System Log Messages
This chapter describes messages with the CFMD prefix. They are generated by the
connectivity-fault management (CFM) process (cfmd), which supports Operation,
Administration, and Maintenance (OAM) functions that are defined in the Institute of
Electrical and Electronics Engineers (IEEE) 802.1ag standard for Ethernet interfaces.
CFMD_CCM_DEFECT_CROSS_CONNECT
System Log Message CFM defect: error-message
Description A connectivity-fault management (CFM) maintenance endpoint (MEP) received a
continuity check message (CCM) that had an incorrect maintenance association (MA)
ID or a maintenance domain (MD) level lower than that of the MEP, each of which
indicates a cross-connect error.
Type Event: This message reports an event, not an error
Severity error
Facility ANY
Cause The configuration is invalid.
Action Check whether the configured MD name, format, and level, or the MA name or format,
is different from the remote endpoint.
CFMD_CCM_DEFECT_ERROR
System Log Message CFM defect: error-message
Description A connectivity-fault management (CFM) maintenance endpoint (MEP) received a
continuity check message (CCM) with an incorrect transmission interval or MEP ID, which
indicates a configuration error.
Type Event: This message reports an event, not an error
Severity error
Facility ANY
Cause The configuration is invalid.
129Copyright © 2010, Juniper Networks, Inc.

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English