CHAPTER 84
SSH System Log Messages
This chapter describes messages with the SSH prefix. They are generated by the ssh-relay
process (ssh).
SSH_RELAY_CONNECT_ERROR
System Log Message Unable to connect to service-name server: error-message
Description The 'ssh-relay' program could not connect to the server process for the indicated service.
Type Error: An error occurred
Severity error
Facility ANY
Cause The server process is not running or has not enabled the service.
SSH_RELAY_SERVER_ERROR
System Log Message SSH relay error for service-name service: error-message
Description The indicated error occurred when a JUNOS process tried to establish secure shell (SSH)
relay during initialization of the indicated service.
Type Error: An error occurred
Severity error
Facility ANY
Cause An internal software failure occurred.
Action Contact your technical support representative.
SSH_RELAY_USAGE
System Log Message Usage: ssh-relay -s service-name
Description The syntax statement for the 'ssh-relay' command was displayed because the command
was invoked with one or more incorrect options, or without necessary options.
617Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...