Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

CHAPTER 66
PGCPD System Log Messages
This chapter describes messages with the PGCPD prefix. They are generated by the pgcpd
process. This process decodes Packet Gateway Control Protocol (PGCP) messages that
virtual packet gateways (VPG) receive from the packet gateway controller (PGC) and
translates these messages to interprocess communication (IPC) messages.
PGCPD_SHUTDOWN
System Log Message The pgcpd process shut down
Description The packet gateway control process (pgcpd) state was shut down.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
PGCPD_STARTUP
System Log Message The pgcpd process just started up
Description The packet gateway control process (pgcpd) just started up
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
PGCPD_SWITCH_OVER
System Log Message switch over
Description Switch over from active to backup Routing Engine
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
471Copyright © 2010, Juniper Networks, Inc.

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English