Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

CHAPTER 72
RMOPD System Log Messages
This chapter describes messages with the RMOPD prefix. They are generated by the
Simple Network Management Protocol (SNMP) remote operations process (rmopd),
which services SNMP requests for execution of ping and traceroute operations.
RMOPD_ADDRESS_MULTICAST_INVALID
System Log Message Multicast address is not allowed
Description When a Simple Network Management Protocol (SNMP) client requests a remote
operation, it can specify the addresses of the source and target hosts for the operation.
A request failed because the client specified a multicast address for either or both the
source and target hosts.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
RMOPD_ADDRESS_SOURCE_INVALID
System Log Message Source address invalid: error-message
Description When a Simple Network Management Protocol (SNMP) client requests a remote
operation, it can specify the address to use as the source host for the operation, along
with the corresponding address type (such as IP version 4 [IPv4]). Either the specified
address was invalid because it did not match the specified address type, or the address
could not be resolved.
Type Error: An error occurred
Severity notice
Facility LOG_DAEMON
RMOPD_ADDRESS_STRING_FAILURE
System Log Message Unable to convert numeric address to string: error-message
Description The remote Simple Network Management Protocol (SNMP) operations process (rmopd)
could not convert a numeric host address to the corresponding hostname text string.
493Copyright © 2010, Juniper Networks, Inc.

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English