CHAPTER 45
L2CPD System Log Messages
This chapter describes messages with the L2CPD prefix. They are generated by the Layer
2 Control Protocol process (l2cpd), which supports the transmission of control messages
for Layer 2 spanning tree protocols in a Layer 2 bridge environment.
L2CPD_ASSERT
System Log Message Assertion failed for executable-name (PID pid) at line line-number in file 'source-filename':
message
Description The source code for the Layer 2 Control Protocol process (l2cpd) includes internal
self-consistency tests. The l2cpd process with the indicated executable name and process
ID (PID) terminated because the indicated test failed at the indicated line number in the
indicated source file. The process created a diagnostic core file for analysis by technical
support personnel.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause Messages that immediately follow this message in the system log might provide
information about possible causes.
Action Contact a technical support representative, and be ready to provide the list of messages
and the diagnostic core file, if requested.
L2CPD_ASSERT_SOFT
System Log Message Assertion failed for executable-name (PID pid) at line line-number in file 'source-filename'
(message); process continued running
Description The source code for the Layer 2 Control Protocol process (l2cpd) includes internal
self-consistency tests. The l2cpd process with the indicated executable name and process
ID (PID) terminated because the indicated type of check failed at the indicated line
number in the indicated source file. The process continued to run, but created a diagnostic
core file for analysis by technical support personnel.
Type Error: An error occurred
359Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
