Severity error
Facility LOG_DAEMON
Cause Messages that immediately follow this message in the system log might provide
information about possible causes.
Action Contact a technical support representative, and be ready to provide the list of messages
and the diagnostic core file, if requested.
L2CPD_EXIT
System Log Message l2cpd process with PID pid exited (was using executable executable-name, version version
built by builder on date); caller was address
Description The Layer 2 Control Protocol process (l2cpd) exited. The process had the indicated
process ID (PID) and was using an executable with the indicated name, version, and
other characteristics.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
Cause Either a system resource was unavailable, the l2cpd process could not interpret an error,
or the indicated user (referred to as a 'caller') terminated the process.
L2CPD_KERNEL_VERSION
System Log Message Kernel version (kernel-version) of routing sockets was not required version (l2cpd-version)
Description The Layer 2 Control Protocol process (l2cpd) determined that the indicated version of
routing sockets, which the kernel supports, is not the version that it requires.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Upgrade the kernel package.
L2CPD_KERNEL_VERSION_OLD
System Log Message Kernel version (kernel-version) of routing socket message type message-type is older
than the required version (l2cpd-version)
Description The Layer 2 Control Protocol process (l2cpd) determined that the kernel supports an
indicated older version of the indicated routing socket message type than it requires.
Type Error: An error occurred
Severity error
Copyright © 2010, Juniper Networks, Inc.360
Junos 10.3 System Log Messages Reference
To Next Page
Loading...