Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Facility LOG_DAEMON
Action Upgrade the kernel package.
L2CPD_KERNEL_VERSION_UNSUPP
System Log Message Kernel version of routing socket message type 'message-type' was not required version
(l2cpd-version)
Description The Layer 2 Control Protocol process (l2cpd) determined that the kernel does not support
the version of the indicated routing socket message type that it requires.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Upgrade the kernel package.
L2CPD_MEMORY_EXCESSIVE
System Log Message Using size KB of memory, percentage-value percent of available
Description The Layer 2 Control Protocol process (l2cpd) was using the indicated amount and
percentage of Routing Engine memory, which is considered excessive.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause Either the l2cpd process is leaking memory or the use of system resources is excessive.
Possible causes include misconfigured routing filters or a very complex configured network
topology.
Action Increase the amount of RAM in the Routing Engine.
L2CPD_MGMT_TIMEOUT
System Log Message Peer peer-name timed out
Description The Layer 2 Control Protocol process (l2cpd) did not receive input from the indicated
management peer within the timeout period.
Type Error: An error occurred
Severity warning
Facility LOG_DAEMON
Cause Messages that immediately follow this message in the system log might provide
information about possible causes.
361Copyright © 2010, Juniper Networks, Inc.
Chapter 45: L2CPD System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English