CHAPTER 26
ESWD System Log Messages
This chapter describes messages with the ESWD prefix. They are generated by the ethernet
bridging process (eswd).
ESWD_BPDU_BLOCK_ERROR_DISABLED
System Log Message interface-name: bpdu-block disabled port
Description This condition occurs when bpdu-block error condition is detected.
Type Error: An error occurred
Severity alert
Facility LOG_DAEMON
ESWD_BPDU_BLOCK_ERROR_ENABLED
System Log Message interface-name: bpdu-block enabled port
Description This condition occurs when bpdu-block error condition is cleared.
Type Error: An error occurred
Severity alert
Facility LOG_DAEMON
ESWD_DAI_FAILED
System Log Message count type received, interface interface-name[index interface-device-index], vlan
vlan-name[index vlan-id], sender ip/mac sender-address/mac1, receiver ip/mac
destination-address/mac2
Description The ARP request/response receieved on this port cannot be linked to any of the IPs
assigned by DHCP.
Type Error: An error occurred
Severity alert
Facility LOG_DAEMON
249Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...