CHAPTER 20
COSD System Log Messages
This chapter describes messages with the COSD prefix. They are generated by the
class-of-service (CoS) process (cosd), which enables the routing platform to provide
different levels of service to applications based on packet classifications.
COSD_AGGR_CONFIG_INVALID
System Log Message Error: Cannot have config error-message interface-name
Description The class-of-service (CoS) process (cosd) did not apply the config on this interface
because it was not valid in this case
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause One possible cause is if any Class-of-Service is configured on an interface which is a part
of an aggregated interface
Action Remove or change the config from/on the interface.
COSD_CHASSIS_SCHED_MAP_INVALID
System Log Message Chassis scheduler map incorrectly applied to interface interface-name: error-message
Description The class-of-service (CoS) process (cosd) did not apply a chassis scheduler map to the
indicated interface, because the configuration used to apply the scheduler map was
invalid.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause One possible cause is that the chassis scheduler map is applied to a specific interface.
For most interface types, a scheduler map must be applied to all interfaces on the PIC;
therefore, a wildcard must be used to specify the interfaces. One exception to this rule
is the Gigabit Ethernet IQ PIC.
213Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...