Action Correct the configuration used to apply the chassis scheduler map to the interface.
COSD_CLASSIFIER_NO_SUPPORT_LSI
System Log Message Cannot support classifier type classifier-type on lsi interface interface-name
Description The Differentiated Services code point (DSCP) classifier and the 802.1p classifier are
only supported on I-Chip based Flexible PIC Concentrators (FPCs).
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Remove the DSCP or the 802.1p classifier configuration from the routing instance
COSD_CLASS_8021P_UNSUPPORTED
System Log Message ieee-802.1 classifier is not valid on interface interface-name
Description The IEEE 802.1p classifier is not supported on the indicated interface.
Type Error: An error occurred
Severity warning
Facility LOG_DAEMON
Action Remove the 802.1p classifier configuration from the interface, or configure an interface
encapsulation type that supports 802.1p classifiers.
COSD_CONF_OPEN_FAILURE
System Log Message Unable to open: filename, using default CoS forwarding classes, do 'commit full' in cli to
avoid this message
Description The class-of-service (CoS) process (cosd) could not read configuration data.
Type Error: An error occurred
Severity error
Facility ANY
Cause All of the following:mgd -I fails after upgrade (cosd.conf does not exist and is not created
because of the mgd -I failure), the first commit is 'commit' and not 'commit full'(cosd.conf
will not commit is 'commit' and not 'commit full'(cosd.conf will not automatically be
created), [class-of-service forwarding-classes] does notexist(the file cosd.conf will not
get exported with plain 'commit')
Action Do a 'commit full'
Copyright © 2010, Juniper Networks, Inc.214
Junos 10.3 System Log Messages Reference
To Next Page
Loading...