Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

CHAPTER 52
LIBMSPRPC System Log Messages
This chapter describes messages with the LIBMSPRPC prefix. They are generated by the
mspinfo process, which is responsible for RPC communication between the Routing
Engine (RE) and the Multiservices PICs.
LIBMSPRPC_CLIENT_INIT_FAILED
System Log Message Can't create msprpc client: error-message
Description A JUNOS process (mspinfo) could not establish initialization of the RPC client.
Type Error: An error occurred
Severity error
Facility ANY
Cause Possible reasons: process is out of memory
Action Contact your technical support representative.
LIBMSPRPC_CLIENT_KCOM_FAILED
System Log Message Can't initialize kcom for msprpc client: error-message
Description A JUNOS process (mspinfo) could not establish initialization of the kcom subsystem.
Type Error: An error occurred
Severity error
Facility ANY
Cause Possible reasons: can't initialize kcom services.
Action Contact your technical support representative.
LIBMSPRPC_CLIENT_KCOM_NO_IF
System Log Message No active extension-provider interfaces
419Copyright © 2010, Juniper Networks, Inc.

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English