Type Error: An error occurred
Severity error
Facility LOG_DAEMON
RMOPD_ADDRESS_TARGET_INVALID
System Log Message rmop_util_set_address status message: error-message
Description When a Simple Network Management Protocol (SNMP) client requests a remote
operation, it must specify the address of the target host along with the corresponding
address type (such as IP version 4 [IPv4]). Either the specified address was invalid
because it did not match the specified address type, or the address could not be resolved.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
RMOPD_ICMP_ADDR_TYPE_UNSUPPORTED
System Log Message Only IPv4 source address is supported
Description When a Simple Network Management Protocol (SNMP) client requests a remote
operation, it can specify the address type (such as IP version 4 [IPv4]) of the source and
target hosts for the operation. The client specified an unsupported address type.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
RMOPD_IFINDEX_NOT_ACTIVE
System Log Message ifindex: snmp-interface-index
Description When a Simple Network Management Protocol (SNMP) client requests a remote
operation, it can specify which interface to use as the source host address, identifying it
by either its numerical index or its name. The indicated index was invalid because it
represents an inactive interface.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
RMOPD_IFINDEX_NO_INFO
System Log Message No information for snmp-interface-index, message: error-message
Description When a Simple Network Management Protocol (SNMP) client requests a remote
operation, it can specify which interface to use as the source host address, identifying it
Copyright © 2010, Juniper Networks, Inc.494
Junos 10.3 System Log Messages Reference
To Next Page
Loading...
Need help?
General
