Description The Layer 2 address learning process (l2ald) detected an error in an interprocess
communication (IPC) message with the indicated characteristics.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
L2ALD_IPC_MESSAGE_INVALID
System Log Message Invalid message received (message type message, subtype message-type):
message-subtype
Description The Layer 2 address learning process (l2ald) received a message with the indicated
characteristics. The message was invalid for the indicated reason.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
L2ALD_IPC_MESSAGE_SEND_FAILED
System Log Message Unable to send IPC message to peer-name identifier
Description The Layer 2 address learning process (l2ald) could not send an interprocess
communication (IPC) message to the indicated Layer 2 peer.
Type Error: An error occurred
Severity warning
Facility LOG_DAEMON
Action Contact your technical support representative.
L2ALD_IPC_PIPE_WRITE_ERROR
System Log Message Unable to write on pipe: error-message
Description The Layer 2 address learning process (l2ald) could not write to an interprocess
communication (IPC) pipe for the indicated reason.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause One possible reason is that there was no reader for the pipe.
Copyright © 2010, Juniper Networks, Inc.350
Junos 10.3 System Log Messages Reference
To Next Page
Loading...