Action Contact your technical support representative.
L2ALD_MAC_LIMIT_REACHED_BD
System Log Message Limit on learned MAC addresses reached for routing instance 'routing-instance', domain
'bridge-domain:vlan-id'; current count is count
Description The Layer 2 address learning process (l2ald) stopped adding addresses to the MAC
address table that were learned by interfaces in the indicated bridging domain, because
the indicated count of learned addresses exceeds the configured or default limit for the
bridge-domain.
Type Event: This message reports an event, not an error
Severity error
Facility LOG_DAEMON
Action Increase the limit on addresses learned by interfaces in the bridge domain, by increasing
the value of the 'interface-mac-limit' statement at the [edit routing-instances
<routing-instance-name> bridge-domains <bridge-domain-name> bridge-options]
hierarchy level.
L2ALD_MAC_LIMIT_REACHED_GLOBAL
System Log Message Global limit on learned MAC addresses reached; current count is count
Description The Layer 2 address learning process (l2ald) stopped adding addresses to the MAC
address table, because the indicated count of learned addresses exceeds the limit for
the router.
Type Event: This message reports an event, not an error
Severity error
Facility LOG_DAEMON
Action Increase the limit on addresses learned by the interfaces on the router by increasing the
value of the 'global-mac-limit' statement at the [edit protocols l2-learning] hierarchy
level.
L2ALD_MAC_LIMIT_REACHED_IF
System Log Message Limit on learned MAC addresses reached for interface-name; current count is count
Description The Layer 2 address learning process (l2ald) stopped adding addresses to the MAC
address table that were learned by the indicated interface, because the indicated count
of learned addresses exceeds the limit configured for the interface.
Type Event: This message reports an event, not an error
Severity error
Facility LOG_DAEMON
351Copyright © 2010, Juniper Networks, Inc.
Chapter 44: L2ALD System Log Messages