Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

IDP_ATTACK_LOG_EVENT
System Log Message IDP: at timestamp, message-type Attack log
<source-address:source-port->destination-address:destination-port> for protocol-name
protocol and service service-name application application-name by rule rule-name of
rulebase rulebase-name in policy policy-name. attack: repeat=repeat-count, action=action,
severity=severity, name=attack-name, NAT
<nat-source-address:nat-source-port->nat-destination-address:nat-destination-port>,
time-elapsed=elapsed-time, inbytes=inbound-bytes, outbytes=outbound-bytes,
inpackets=inbound-packets, outpackets=outbound-packets,
intf:source-zone-name:source-interface-name->destination-zone-name:destination-interface-name,
packet-log-id: packet-log-id and misc-message message
Description IDP Attack log generated for attack
Type Event: This message reports an event, not an error
Severity info
Facility LOG_PFE
IDP_COMMIT_COMPLETED
System Log Message IDP policy commit is complete.
Description IDP policy commit has completed. Policy compile and load however may have been a
success or failure.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_AUTH
IDP_COMMIT_FAILED
System Log Message IDP policy commit failed. Exiting from compilation.
Description There was an error while trying to commit the active policy in IDPD. Device will continue
running the current IDP policy.
Type Error: An error occurred
Severity error
Facility LOG_AUTH
IDP_DAEMON_INIT_FAILED
System Log Message Aborting...A failure was encountered;error-message
Description An attempt to start IDP policy daemon failed because an error was encountered during
initialization.
Type Error: An error occurred
Copyright © 2010, Juniper Networks, Inc.298
Junos 10.3 System Log Messages Reference

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English